Before Use - Disassembly And Assembly - Panasonic MX-ZX1800 Operating Instructions Manual

Before Use - Disassembly and Assembly -

Disassembly and assembly of the blender container base
<Disassembly>
1
Attach the container base holder while aligning
the ▲ marks on the container base and
container base holder. Then turn it anticlockwise
firmly.
2
Pull out the container base holder.
Do not press tabs on the container base
holder to avoid the blender container base
falling.
Tab
(Both side)
3
Press tabs on the container base holder to
release the blender container base from it.
Tab
(Both side)
CAUTION:
● Pay attention when handling the blender container base. Blades are sharp.
● If the gasket is not attached to blender container and/or the blender container base is not attached firmly onto
the blender container, liquid may leak out.
<Assembly>
1
Attach the container gasket into
the groove on bottom of the
blender container.
(Failure to install the container
gasket completely into the groove
may lead to leaking liquids.)
2
Attach the container base holder while aligning the
▲ mark on the blender container base and
container base holder, then press the container base
holder until you hear a click sound.
3 Insert the blender container base into the blender
container after aligning, then turn the container base
holder clockwise until it stops turning. ( The "O"
mark on the blender container base will align with
the line on the blender container.)
4
Press tabs to remove the container base holder.
Tab
(Both side)
Disassembly and assembly of the cover unit
<Disassembly>
1
Pull up the tab to open the cover.
2
Turn the cap anticlockwise and pull up to
remove it.
CAUTION:
● When you force open the cover unit, be careful
not to let any liquid splash. Additionally, take
caution with the emerging steam, especially
when blending hot liquids.
Assembly of the ice pack and drip tray
<Ice pack>
Use the ice pack tape strips to secure the ice pack over and
under the blender container handle with the label facing the inner side of the pack.
<Drip tray>
Set the drip tray onto the motor housing and push it down completely.
CAUTION:
When removing the drip tray after blending, beware of water spillage.
<Assembly>
1
Attach the cover gasket properly onto the cover
groove, align the cover with the ▼ mark on the
cap. Then turn the cap clockwise until the ▼ mark
on the cover aligns well with the portion on the
cap and you hear a click sound. (If the cover
gasket is not properly installed, liquid may leak
through the cover.)
2
Place the cover unit on the blender container and
press down.
CAUTION:
● Make sure the cover unit is attached firmly.
Correct Incorrect
● When the tamper is not in use, make sure to attach
the cap while blending.
● When using the "frozen" menu selection, insert the tamper
from the cover opening instead of attaching the cap.