Download  Print this page

Overload Protection; Replacement Parts; Specifications - Panasonic MX-ZX1800 Operating Instructions Manual

Hide thumbs

Advertisement

Troubleshooting
Problem
● The blender container base is attached loosely.
→ Tight the container base up firmly onto the blender container. (P. EN10)
● The gasket of the lid or blender container is not attached correctly.
container is leaking.
→ Attach the gasket correctly. (P. EN10)
● The gasket of the lid or blender container is damaged.
→ Replace the gasket. (P. EN21)
● Too much ingredients in the blender container.
There is abnormal noise
→ Stop the appliance and reduce the ingredients.
or vibration.
● The blender container base is attached loosely.
→ Tight the blender container base up firmly onto the blender container. (P. EN10)
● Too much Ice cubs or frozen fruit.
→ Turn off the appliance and after the blade is completely stopped,
The blade is spinning.
insert the tamper to circulate. (P. EN15)
● Quantity of the liquid is low.
→ Add liquid.
● When you are blending quantity of less or over 4 servings, texture and
consistency may not turn well on auto menus.
→ Try using the manual mode. (P. EN16-EN17)
The
and
indicators
● This is a malfunction.
→ Contact an authorized Panasonic service center for check and repair.
The
and
indicators
● The overheating protection is activated.
・Too many ingredients
・Using hard ingredients
The appliance stops
・Selected speed is too low for ingredients
during blending and
and
→ Turn off the appliance and wait 10 minutes before next use.
* There is a possibility of failure if it is re-used immediately.
When re-using the appliance, allow the blade to rotate freely by
reducing the amount of ingredients or by increasing the speed.

Overload Protection

disable the protection.
2. Turn the motor housing over, and press the reset button on its bottom.
setting, press "
" to blend again.

Replacement Parts

Part name
Container gasket
Cover gasket
Ice pack

Specifications

Power supply
Power consumption
Speed control
Operation rating
Working capacity
Dimensions (W × D × H) (approx.)
Mass (approx.)
Length of the power cord (approx.)
Reset
Circuit breaker
(on the bottom)
Part number
VE28B246
VE22B246-K0
VU03A246
MX-ZX1800
120 V
60 Hz
1200 W
10 speed control
Continuous operation (Repeat the cycle of 9 min ON and then 10 min OFF)
1800 mL (60 oz.)
22 × 24 × 44.7 cm (8.7 × 9.4 × 17.6 inches)
6.3 kg (13.9 lb)
1.9 m (75 inches)

Advertisement

Table of Contents
loading