4) Remove the screw and remove the U-turn guide.
2)
Pressure roller section disassembly
5) Remove the three screws, remove the fusing cover lower on the
right side, and open the heat roller section.
Note: When opening the unit after removing the screw 4), be care-
ful not to deform the earth spring.
2)
4)
3)
6)
5)
6) Remove the screw and remove the PPD2 sensor.
1)
1)
6)
5)
1)
2)
PPD2 sensor
AL-2030/2040CS/2050CS
DISASSEMBLY AND ASSEMBLY 8 - 6
7) Remove the plate spring on the right and remove the heater
lamp.
2)
Heater lamp
8) Remove the spring, and remove the upper separation pawls (3
pcs.).
2)
1)
9) Remove the E-ring and remove the reverse gate.
3)
1)
1)
3)
2)