Sharp AL-2020 Service Manual page 102

Main Sub
Contents
code code
26 06 Destination setup
07 Machine conditions check
20 Rear edge void setup
30 CE mark support control
ON/OFF
38 Cancel of stop at drum life
over
39 Memory capacity check
[Function]
When this simulation is executed, the current set destination is displayed. Enter the code num-
ber corresponding to the desired destination and press [OK]/[START] key to save the setting.
Code number
0
1
2
* Code number 2 cannot be selected.
[Operation]
The operation is similar to simulation 26-02.
[Function]
When this simulation is executed, the current machine setting is displayed.
CPM
20 CPM
[Operation] (AL-2050/2060)
1) The machine setting is displayed.
26-07 CPM
20 CPM
[Function]
When this simulation is executed, the current set rear edge void is displayed. Enter the code
number corresponding to the desired rear edge void and press [OK]/[START] key to save the
setting.
Code number
0
1
[Operation]
The operation is similar to simulation 26-02.
[Function]
When this simulation is executed, the current set CE mark support control is displayed. Enter
the code number corresponding to the desired CE mark support control and press [OK]/
[START] key to save the setting.
Code number
0
1
[Operation]
The operation is similar to simulation 26-02.
[Function]
When this simulation is executed, the current setup of the code number is displayed. Enter the
code number and press the PRINT switch to enable the setup.
Code number
0
1
[Operation]
The operation is similar to simulation 26-02.
[Function]
When the simulation is executed, the currently installed SDRAM of the main unit is displayed.
Code number
8
16
[Operation] (AL-2050/2060)
1) Memory capacity display
26-39 MEM.CHK
8 MBYTE
AL-2020/2035/2040/2050/2060 SIMULATION, TROUBLE CODES 10 - 12
Details of function/operation
Destination
Inch series
EX Japan AB series
Japan AB series
Copy quantity Remark
20
Setting Display item
Rear edge void NO
Rear edge void YES
Setting
CE mark support control OFF
CE mark support control ON
Setup
Stop at drum life over * Default (AL model)
Cancel of stop at drum life over
Setting Remark
8 MBYTE
16 MBYTE
Display item
INCH
Remark
OFF
ON Default
Display item Remark
OFF Default (100V series)
ON
AB
–