Sharp AL-2020 Service Manual page 127

Main Sub
Contents
code code
66 18 DTMF signal send
(Soft SW set value)
(AL-2060 only)
21 FAX information print
(AL-2060 only)
24 FAST SRAM clear
(AL-2060 only)
30 TEL/LIU status change
check (AL-2060 only)
[Function]
Use to set the DTMF signal send (Soft SW set value).
[Operation]
1) Initial display
INPUT DIAL #
∗ [Clear] key: FAX control is terminated.
2) [Numeric] key: Input
The content selected with signal send
level selection is set inside.
[Function]
Use to print the FAX information.
[Operation]
1) Initial display
SELECT REPORT (1-3)
PRESS ←, →
2) [ ] [ ] key or after 2sec
Every time when [
→ 3 → 1.
When [ ] key is pressed, the sequence is reversed.
SELECT REPORT (1-3)
1:USER SW. LIST
∗ [Clear] key: FAX control is terminated.
3) [OK] key
• When print is allowed
PRINT STORED
After completion of printing,
FAX control is terminated.
[Function]
Use to clear the FAST SRAM.
[Operation]
1) Initial display
CLEAR FAST SRAM
[Function]
Use to check the TEL/LIU status change.
[Operation]
1) Initial display
HS2 :xxx HS1 :xxx
RHS :xxx EXHS:xxx
↑
The display is switched every 2sec.
↓
CHECKING
PRESS CLEAR TO STOP
∗ [Clear] key: FAX control is terminated.
AL-2020/2035/2040/2050/2060 SIMULATION, TROUBLE CODES 10 - 37
Details of function/operation
3) Communication is started after setting the
signal send level.
SENDING SIGNAL SSW
PRESS CLEAR TO STOP
∗ [Clear] key: Returns to "1) Initial display".
] key is pressed, the second line is changed in the sequence of 1 → 2
SELECT REPORT (1-3)
2:SOFT SW. LIST
• When print is inhibited
CAN NOT PRINT
After 2sec, FAX control is
terminated.
2) After completion of clearing
CLEARED
After 2sec, FAX control is terminated.
SELECT REPORT (1-3)
3:PROTOCOL