Changing The Engine Oil - Yamaha XVS1300A 2007 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
ECA11C1001
CAUTION:
• Engine oil also lubricates the clutch and the
wrong oil types or additives could cause
clutch slippage. Therefore, do not add any
chemical additives or use engine oils with a
grade of CD "a" or higher and do not use
oils labeled "ENERGY CONSERVING II"
"b".
• Do not allow foreign materials to enter the
crankcase.
3. Start the engine, warm it up for several min-
utes, and then turn it off.
4. Check the engine oil level again.
NOTE:
Before checking the engine oil level, wait a few
minutes until the oil has settled.
EAS20780

CHANGING THE ENGINE OIL

1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
• Engine oil drain bolt "1"
(along with the gasket)
4. Drain:
• Engine oil
(completely from the crankcase)
email: info@motomatrix.co.uk
5. If the oil filter cartridge is also to be replaced,
M
a. Remove the oil filter cartridge "1" with an oil
b. Lubricate the O-ring "3" of the new oil filter
ECA13390
CAUTION:
Make sure the O-ring "3" is positioned cor-
rectly in the groove of the oil filter cartridge.
c. Tighten the new oil filter cartridge to specifi-
L
6. Install:
1
7. Fill:
3-11
perform the following procedure.
MMM M MMM M M MMM M M MMM M
filter wrench "2".
Oil filter wrench
90890-01469
YM-01469
1
cartridge with a thin coat of engine oil.
cation with an oil filter wrench.
Oil filter cartridge
17 Nm (1.7 m·kg, 12 ft·lb)
LLL L LLL L L LLL L L LLL L
• Engine oil drain bolt
(along with the gasket
Engine oil drain bolt
43 Nm (4.3 m·kg, 31 ft·lb)
• Crankcase
(with the specified amount of the recom-
mended engine oil)
ENGINE
M MMM M M MMM M MMM
2
L LLL L L LLL L LLL
New )