Installing The Clutch - Yamaha XVS1300A 2007 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
a
1
2. Bend lock washer tabs along a flat side of the
nut.
EAS25240

INSTALLING THE CLUTCH

1. Install:
• Oil/water pump drive sprocket "1"
• Oil/water pump drive chain "2"
• Oil/water pump drive chain guide "3"
NOTE:
Install the oil/water pump drive sprocket with its
projections "a" facing outward.
Oil/water pump drive chain guide
bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
LOCTITE®
a
1
a
email: info@motomatrix.co.uk
c
b
3
2
4
5
2
3
2. Install:
• Clutch housing "1"
NOTE:
• Fit the projections "a" on the oil/water pump
drive sprocket into the grooves "b" in the clutch
housing.
• Lubricate the clutch housing bearing with en-
gine oil.
• Make sure that the primary driven gear teeth
and primary drive gear teeth mesh correctly.
• After installing the clutch housing, make sure
that the primary drive gear "2" and clutch hous-
ing primary driven gear "3" are aligned as
shown in the illustration.
a
3
3. Install:
• Clutch boss assembly "1"
NOTE:
• Install the clutch damper spring "2" with the
"OUTSIDE" mark facing out.
• If the wire circlip "3" has been removed, care-
fully install a new one.
2
5-53
CLUTCH
a
b
1
b
1
3
New
2