Operation - Oven; About The Oven; Operation - Bosch HDI7032C Use And Care Manual

Setting the Burner Heat
Level
Burner Control Knob
Lighting the Burner
Setting the Flame Size
Turning the Burner off

Operation - Oven

About the Oven

Operation

English 18
.
Push in an turn the knob counterclockwise to the
Note: If the burner does not light within four seconds, turn the burner off. Verify
that the burner cap is positioned correctly on the burner base and that the ignitor
is clean and dry. If the burner still fails to ignite, see "Cooktop Troubleshooting
Chart" on page 42
Caution: All ignitors spark when any single burner is turned on. Do not touch
any of the burners when the cooktop is in use.
Lighting the Burner during a Power Failure
Cooktop burners can be lit manually during a power failure. Hold a match at the
port and turn the knob to the HI position. Wait until the flame is burning all the
way around the burner before adjusting the flame to the desired setting.
After lighting, turn the knob counterclockwise to the desired flame size.
See "Cooking Guide" on page 24 for recommended burner settings.
Caution: To prevent possible burns or possible damage to the pan or the appli-
ance, the flame should not extend beyond the edge of the pan.
Turn knob clockwise to the OFF position.
Note: an "pop" may be heard when the burner is turned off. The "pop" may be
louder with LP gas than with natural gas. This is normal.
This section explains how to operate the oven. See "Getting the Most Out of
Your Oven" on page 25 for guidelines to improve oven results.
Figure 15: Burner Control Knob
symbol.