12
SERVICE WORK ON THE CHASSIS
12.10
Adjusting the play of the steering head bearing
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Remove screws
–
Remove screws
L02740-10
–
Fix handlebar
–
Loosen screws
L02741-10
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
L02741-11
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screw
Guideline
Screw, top steering stem
L02741-12
–
Position steering damper
Guideline
Screw, steering damper
–
Remove the cable tie(s) and place the handlebar onto the handlebar clamp base.
–
Mount the holding plate with the handlebar clamps and position the handlebar.
Mount and tighten screws
Guideline
L02740-10
Screw, handlebar clamp
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
. Remove the holding plate with handlebar clamps.
. Take off steering damper
onto the instrument support with cable tie(s)
and
.
.
.
.
. Mount and tighten screws
.
p. 44)
.
.
M20x1
12 Nm (8.9 lbf ft)
M8
17 Nm
(12.5 lbf ft)
M8
20 Nm
(14.8 lbf ft)
.
M6
15 Nm
(11.1 lbf ft)
M8
16 Nm
(11.8 lbf ft)
p. 49)
p. 44)
50