Electrical System; Removing The Battery; Installing The Battery - KTM 2015 450 Rally Factory Replica Owner's Manual

15

ELECTRICAL SYSTEM

15.1

Removing the battery

Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
15.2

Installing the battery

Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
Main work
–
Disconnect the negative (minus) cable
–
Disconnect the positive (plus) cable
L02790-10
–
Remove screws
–
Raise electronics box
–
Detach rubber band
–
Lift the battery up and remove it.
L02791-10
Main work
–
Place the battery in the battery holder.
Lithium-ion battery (
–
Raise electronics box
–
Reconnect rubber band
–
Mount and tighten screws
L02791-11
–
Attach positive cable
Guideline
Nut, cable on battery
–
Attach negative cable
Guideline
Nut, cable on battery
L02790-11
Finishing work
–
Mount the seat. (
p. 54)


of the battery.

.

in the rear area.

at the bottom.
p. 105)
 in the rear area.

.

.

.

.
p. 55)
of the battery.
M6 5 Nm (3.7 lbf ft)
M6 5 Nm (3.7 lbf ft)
84