Table of Contents
Advertisement
16
COOLING SYSTEM
16.4
Draining the coolant
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the
engine and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water imme-
diately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swal-
lowed, contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of
children.
16.5
Refilling coolant
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water imme-
diately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swal-
lowed, contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of
children.
–
Stand the motorcycle upright on a horizontal surface.
–
Remove the radiator cap.
–
Check the coolant level in the radiator.
Coolant level
fins.
»
If the coolant level does not meet specifications:
–
Correct the coolant level.
Coolant (
400243-10
–
Mount the radiator cap.
Condition
The engine is cold.
–
Stand the motorcycle upright.
–
Place a suitable container under the water pump cover.
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw, water pump cover
L02797-11
–
Make sure that screw
–
Stand the motorcycle upright.
–
Pour coolant in up to measurement
Guideline
Coolant level
fins
Coolant
L02798-10
–
Mount the radiator cap.
–
Take a short test ride.
–
Check the coolant level. (
above the radiator
p. 124)
. Remove radiator cap
with a new seal ring.
is tightened.
above the radiator fins.
above the radiator
1.2 l (1.3 qt.)
p. 88)
10 mm (0.39 in)
.
M6
10 Nm (7.4 lbf ft)
10 mm (0.39 in)
Coolant (
p. 124)
89
Advertisement
Table of Contents
