Service Work On The Engine; Checking The Engine Oil Level; Changing The Engine Oil And Oil Filter, Cleaning The Oil Screens - KTM 2015 450 Rally Factory Replica Owner's Manual

18

SERVICE WORK ON THE ENGINE

18.1

Checking the engine oil level

18.2

Changing the engine oil and oil filter, cleaning the oil screens

Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
Condition
The engine is at operating temperature.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Condition
The engine is cold.
–
Check the engine oil level.
The engine oil level is between
»
When the engine oil level is below the
L02800-10
–
»
When the engine oil level is at or above the
–
Preparatory work
–
Park the motorcycle on a level surface.
–
Remove the engine guard. (
Main work
–
Place a suitable container under the engine.
–
Remove oil drain plug
L02810-10
–
Remove screw plug
L02814-10
Info
After switching off the engine, wait a minute and then check.

Add engine oil. ( p. 95)
Correct the engine oil level.
p. 68)

with the magnet and seal ring.

with the short oil screen and the O-rings.

and .

marking:

marking:
92