Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
12.40
Changing the hydraulic clutch fluid
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
12.41
Removing the trim
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
L02719-10
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the slave cylinder, remove bleeder screw
L02761-10
–
Inject the liquid into the system until it escapes from openings
cylinder without bubbles.
–
To prevent overflow, drain the fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level under top level of container
–
Position the cover with the membrane. Mount and tighten the screws.
L02762-10
–
Disconnect plug-in connectors
L02763-10
.
with membrane
.
with the appropriate fluid.
p. 124)
of the turn signals.
and mount bleeding syringe
of the master
4 mm (0.16 in)
66
.
Advertisement
Table of Contents
