Adjusting The Tri-Fold Positions - Konica Minolta bizhub 750 User Manual

Utility
13
Repeat steps 7 through 12 until the desired print results are achieved.
14
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
Note
Enter the value by mm using the keypad. Refer to the conversion rate be-
low. 1 in. = 25.4 mm
When PK-505 and ZU-602 are installed, adjustments can be made using
both the "Punch Adjustment" and "Z-Fold Position Adjustment" param-
eters. Contact your technical representative.

Adjusting the Tri-Fold Positions

The folding positions when using the "Tri-Fold" setting can be adjusted.
0 Use the "Tri-Fold" function to print a single sample copy, and then per-
form the adjustment while checking the sample that was created.
1
Display the Administrator Setting screen.
2
Touch [1 System Setting].
The System Setting screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [5 Tri-Fold Position].
The Tri-Fold Position screen appears.
bizhub 750/600
12
12-75