Konica Minolta bizhub 750 User Manual page 279

7
4
Type in the length (X) and width (Y) of the paper.
– Touch [X], touch [↔] to switch between the integer and the fraction,
and then touch [–] and [+] to type in the length of side X. (5-1/2 in.
to 18 in.)
– Touch [Y], touch [↔] to switch between the integer and the fraction,
and then touch [–] and [+] to type in the length of side Y. (3-15/16
in. to 12-5/16 in.)
– If a decimal value is displayed in the screen, use the keypad to type
in the length. For details on switching between decimal and fraction
values, refer to "System Setting" on page 12-19.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message "Input Error" appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
Can paper sizes be stored?
?
% Five specified non-standard paper sizes can be stored.
% For details on storing paper sizes, refer to "To store a non-standard
paper size (Custom Size settings Store)" on page 7-15.
% To recall a stored paper size, touch the memory key.
% The names of the memory key can be changed. For details on
changing the names, refer to "To store a non-standard paper size
(Custom Size settings Store)" on page 7-15.
5
Touch [OK] three times.
The Basic screen appears again.
7-14
Copy Paper/Original
bizhub 750/600