Disposal Of The Old Device; Environment And Recycling - REMKO MKT 250 Operation Manual

Disposal of the old
device
The unit production is subject to
continuous quality control.
Only high-quality materials are used,
the majority of which are recyclable.
You also contribute to environmental
protection by guaranteeing that your
old equipment is disposed of in an
environmentally friendly manner.
For this reason, bring the old equip-
ment only to an authorised recycling
company or to a corresponding
disposal site.

Environment and Recycling

Dispose of the packaging in an
■
ecofriendly manner.
Do not dispose of the device in
■
domestic rubbish.
Both the refrigerant and the plant parts
■
are subject to special disposal
conditions.
The refrigerant used belongs to the
■
chlorofluorocarbon refrigerant group. If
it is released into the air due to damage
to the cooling circuit, injury to the respi-
ratory organs of people and animals will
not occur.
Fig. 19
Installation diagram
for the wall bushing
Telescopic
pipe
Protective
grille
Installation Instructions for the Wall
Create a core hole in the outside wall
■
(max.- wall thickness of 480 mm) with a
diameter of at least 135 mm.
Take the minimum distance of 430 mm
■
between the floor (mounting surface of
the device) and the centre of the wall
bushing into consideration.
Insert the telescopic pipe into the wall
■
bushing
To prevent cold bridges, insulate the
■
telescopic pipe with suitable insulating
material.
Wall the telescopic pipe into the core
■
hole in such a way that it is flush to both
sides of the wall.
Sealing cap
Trap
Mount the protection grill on the out-
■
side of the wall (make sure it is protect-
ed from rain).
Fix the trap to the inside.
■
The "top" label on the trap must be
■
legible from the inside!
When taking the device out of service,
■
for example, at the beginning of winter,
close the opening of the trap using the
sealing cap to prevent air circulation.
10