Table of Contents
Advertisement
REMKO MKT
Electrical wiring diagram
Control panel
Microswitch
Temperature
sensor
Technical dimensions and design sub-
ject to alteration
Fig. 18 Electrical wiring diagram
Taking out of service
To take the device out of service,
deactivate it first by pressing the "Power"
button. Then pull the mains plug.
If the device must be shut down for a
longer period of time, for example, for
storage during the winter, observe the
following:
1. Let the machine run for about two
hours in the "Fan" mode to dry the sur-
face of the evaporator plate fins. In this
way, the residual moisture is removed
from the device and you can prevent
unpleasant smells during recommission-
ing.
2. Switch off the device, pull the mains
plug, and roll up the mains supply line.
3. Drain the condensate (s. p. 6).
9
Evaporator fan
Red
Orange
Yellow
Hi Med Lo
J01
L
RL101
L
COMP
Warranty
The function of the device was precisely
■
checked several times at the factory. If
malfunctions that are not described in
the "Trouble Shooting" chapter (s. p.
7) still appear, contact your dealer or
contractual partner.
In order for REMKO to assume the
■
warranty, the "Warranty Certificate"
included in delivery must be completely
filled out and sent to REMKO GmbH &
CO KG immediately after purchasing or
commissioning.
White
Condenser
L
N
Brown
E
Red
Red
Red
Condenser
Condenser
Compressor
Evaporator fan
Mains plug
Reservoir motor
CAUTION
The manufacturer is not li-
able for damage that occurs
due to nonobservance of
manufacturer instructions or
the legal requirements or due
to unauthorised changes to
the device.
Advertisement
Table of Contents
