Table of Contents
Advertisement
"Cool" mode
1. Attach the air outlet hose to the wall
bushing or the window.
2. Activate the device using the "Power"
button (1) .
3. Press the "Mode" button (2) until the
"Cool" LED (9) lights up.
4. Select the fan setting using the "Fan
Speed" button (3):
"High" highest speed
"Med" medium speed
"Low" lowest speed
5. If the "Room Temp." LED (12) lights up,
the current room temperature is shown
in the display (7).
6. As soon as the (4/5/6) button is
pressed, the display switches from the
room temperature to the set tempera-
ture (LED 13 lights up) and shows the
desired temperature for 15 seconds.
7. Set the desired room temperature using
the "Timer/Temp. Adjust" button (5/6).
The up arrow (5) increases the set value
shown in the display (7), while the
down arrow (6) decreases it.
TIP
"Cool" mode
You can achieve a pleasant
room climate by selecting
a set temperature that is a
maximum of 4 to 7°C below
the outdoor temperature.
"Dehumidify" mode
1. Attach the air outlet hose to the wall
bushing or the window.
2. Activate the device using the "Power"
button (1).
3. Press the "Mode" button (2) until the
"Dehumidify" LED (9) lights up; the fan
is automatically switched to the "Med"
or medium fan speed stage.
"Fan"mode
1. Activate the device using the "Power"
button (1).
2. Press the "Mode" button (2) until the
"Fan" LED (9) lights up.
3. Select the fan setting using the "Fan
Speed" button (3):
"High" highest speed
"Med" medium speed
"Low" lowest speed
4. The room temperature is not influenced
and remains constant. For this reason,
the temperature and time setting
"Timer/Temp. Adjust" buttons (5/6)
cannot be used.
"Timer" time delay (4)
You can turn the device on and off
automatically using the timer. To do so,
an activation/deactivation delay is pro-
grammed.
Automatic activation
■
1. Activate the device using the
"Power" button (1).
2. Select the mode and make all set-
tings for the desired mode.
3. Deactivate the device using the
"Power" button (1) .
4. Press the "Timer" button (4).
5. Set the time using the "Timer/
Temp. Adjust" button (5/6).
Only whole hours can be entered.
6. The LED (11) flashes.
7. The device activates automatically
at the set time.
Automatic deactivation
■
1. The device is running in the previ-
ously set mode.
2. Press the "Timer" button (4).
3. Set the remaining run time using
the "Timer/Temp. Adjust" button
(5/6).
Only whole hours can be entered.
4. The LED (11) flashes.
5. The device deactivates automati-
cally at the set time.
6
Advertisement
Table of Contents
