SMART board 8000i-G4 series Setup And Maintenance Manual page 5

IMPORTANT INFORMATION
This SMART product should be used only with European TN and TT power distribution
l
systems.
It is not suitable for older, IT-type power distribution systems found in some European
countries. "This system (IT-type) is widely used isolated from earth, in some installations in
France, with impedance to earth, at 230/400V, and in Norway, with voltage limiter, neutral
not distributed, at 230V line-to-line." (IEC 60950:1999)
Contact qualified personnel if you're uncertain of the type of power system available where
you're installing your SMART product.
You must connect the USB cable that came with your SMART Board® interactive flat panel
l
to a computer that has a USB compliant interface and that bears the USB logo. In addition,
the USB source computer must be compliant with CSA/UL/EN 60950 and bear the CE mark
and CSA and/or UL Mark(s) for CSA/UL 60950. This is for operating safety and to avoid
damage to the SMART Board interactive flat panel.
IMPORTANT
The following are the power requirements for your interactive flat panel:
l
Model
8070i-G4-SMP
8084i-G4-SMP
For additional requirements and other information, refer to your interactive flat panel's
l
specifications (see Specifications on page 10).
iii smarttech.com/kb/170446
Power requirements
100–240V, 8.9–4.5A, 50/60Hz, 310W
100–240V, 50/60Hz, 530W