Install Decorative Glass Set 1500Dgs - Valor 1500IN (NG) Installation & Owner's Manual

QUALIFIED
INSTALLER

Install Decorative Glass Set 1500DGS

Material required
• Middle platform brackets (supplied with set)
• Small container to distribute fi reglass (not included)
• Decorative Glass Set, which contains:
◊ 3 bags of crushed glass
◊ 1 metal tray for glass
IMPORTANT: Approved for use only with the fi reglass
provided with your Valor fi replace or the fi reglass
brands American Fireglass™ or fi regear. The use of
any other fi reglass products may void your fi replace
warranty.
Installation
Carefully unpack the kit.
1. Install both platform brackets in front of and behind
the burner, with the tabs downward fi tting the
bracket tabs into the burner support's slots as
indicated.
Top
Bottom
2. Install the metal tray on top of the brackets as
indicated. The tray, when installed properly, is fl ush
with the front edge of the fi rebox opening. As well,
the small round hole in the tray should be at the rear
left when facing the fi rebox.
Installed tray
48
Installation
3. Carefully spread the fi reglass in the tray and on the
CHOKING HAZARD! Ensure that the fi replace
area is clear of fi reglass particles as these could
be ingested by small children. Vacuum area after
installation.
Small round
hole at rear
left of fi rebox
Edge of tray fl ush
with edge of fi rebox
burner. Do not overfi ll the burner to avoid blocking
the burner ports. Ideally, one layer of fi reglass on
the burner is suffi cient.
Pilot shield
Fireglass installed—top view
NOTE: Ensure the area around the pilot shield is
not piled too high with fi reglass and also ensure the
area within the pilot shield is clear of fi reglass.
Pilot shield
WARNING
!