LACP enabled
Having set up the aggregator setting with LACP enabled, you will see the trunking group information between two switches
on the tab of Aggregator Information.
Switch 1 configuration
1.
Set System Priority of the trunk group. The default is 32768.
2.
Select a trunk group ID by pulling down the drop-down menu bar.
3.
Enable LACP.
4.
Include the member ports by clicking the Add button after selecting the port number and the column field of
Work Ports changes automatically.
5.
Click on the tab of Aggregator Information to check the trunk group information as the illustration is shown
above after the two switches configured.
Switch 2 configuration
6.
Set System Priority of the trunk group. For example: 1.
7.
Select a trunk group ID by pulling down the drop-down menu bar.
8.
Enable LACP.
9.
Include the member ports by clicking the Add button after selecting the port number and the column field of
Work Ports changes automatically.
Figure 4-5-2-3: Aggregation Information of
Switch 1
94
User's Manual of VC-820M