Planet VC-820M User Manual page 18

system setting.
Users can use the attached DB9 to RJ45 console cable in the package and connect to the console port on the device.
After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix,
Winterm and so on) to enter the startup screen of the device.
1. The payload rate is about 9% less than the line rate due to framing overhead.
2. AWG 26 (0.4mm) cable can also be used but the distance is 20% to 40% shorter than the
above table.
3. Each terminated bridge tap can reduce the VDSL link distance by 90m.The quality of the
cable, the size of the cable bundles, and the cross talk within the bundle can also affect the
overall reach.
■ Alarm Interface
The alarm port is an RJ45 port connector. It is an interface for connecting a sensor directly. Please refer chapter 4.2.9
to enable alarm function
■ Reset Button
On the left of the front panel, the reset button is designed to reboot the Managed Switch without turning off and on the
power. The following is the summary table of Reset button functions:
Reset Button Pressed and Released
< 5 sec: System Reboot
> 5 sec: Factory Default
■ AC Power Receptacle
For compatibility with electrical service in most areas of the world, the Managed Switch's power supply automatically
adjusts to line power in the range of 100-240V AC and 50/60 Hz.
Plug the female end of the power cord firmly into the receptacle on the rear panel of the Managed Switch and plug the
other end of the power cord into an electrical outlet, and the power will be ready.
The device is a power-required device, which means it will not work till it is powered. If your networks
should be active all the time, please consider using UPS (Uninterrupted Power Supply) for your device.
Power Notice:
It will prevent you from network data loss or network downtime.
Function
Reboot the Managed Switch.
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as shown below:
Default username: admin
。
Default password: admin
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default gateway: 192.168.0.254
。
18
User's Manual of VC-820M