Use And Operation; Description Of Robot Commands; Operating Tips - Stiga Autoclip 720S User Manual

Hide thumbs

Table Of Contents

Table of Contents

– When using the robot for the fi rst time, it is recommended to carefully read

the entire manual and to fully understand it, especially the safety information.

– Only use the robot for the uses intended by the Manufacturer and do not

tamper with any device to obtain different operating performances

The illustration shows the position of the

commands on the machine.

A) DISPLAY: it is lit up to display the functions.

B) ON: press to start the mower.

C) START/PAUSE: press to stop the mower,

leaving the display on "stand-by"; in this

way, the mower can be programmed.

Press again to restart the mower. If the key

is pressed while the mower is charging,

the mower does not resume working until

it is pressed again and the word "PAUSE"

disappears from the display.

D) CHARGE: press this key to allow the mower to return to its station and, consequently,

to start recharging the batteries. If pressed while the robot is being charged, the robot

interrupts the charging cycle and starts operating again.

E) OFF/STOP: press this key to stop the robot, the display turns off.

F) "+" KEY: during operation, press this key to restart the blade. During programming, press

this key to increase the values proposed by the menu.

G) ENTER: during operation, press this key to activate the spiral function. During programming,

press to confi rm and memorise the selection.

H) "-" KEY: during operation, press to stop the blade. During programming, press to decrease

the entries proposed by the menu.

I) STOP/Emergency KEY: Press to stop the mower safely. Only use in case of imminent

danger and to perform maintenance on the robot.

User's manual