Main Components - Stiga Autoclip 720S User Manual

A-Battery: supplies power to the blade and wheel motors. The robot is supplied with one or two
lithium batteries which guarantee longer mowing times
B-Charging Station: this is needed to recharge or keep the batteries charged (A)
C-Mother board: controls the automatic functions of the robot.
D-Control keyboard: used to set and display the operating modes of the robot.
E-Cutting blade: mows the lawn
F-Electric motor: operates the cutting blade (E).
G-Electric motor: one operates the right-wheel transmission unit, while the other operates the
EN left wheel.
H-Transmitter: transmits the signal to the perimeter wire
L-Power supply unit: supplies power, in low voltage, to the batteries.
M-Bumper sensor: detects when the robot is about to hit an obstacle that is higher than 10 cm
(3.94 in.) and enables the random change of direction
P-Rain sensor: detects rain and commands the robot to return to the charging station (P).
Q-Sensor: detects the perimeter wire and enables the robot to change its direction in a random
manner.
R-Handle: used to lift and carry the robot.
PERIMETER WIRE SENSOR (Q)
ELECTRIC MOTOR (F)
CUTTING BLADE (E)
User's manual

MAIN COMPONENTS

CONTROL KEYBOARD (D)
BATTERY (A)
MOTHER BOARD (C)
BUMPER
SENSOR (M)
ELECTRIC MOTOR (G)
RAIN SENSOR (P)
POWER SUPPLY
UNIT (L)
TRANSMITTER (H)
8
LIFTING HANDLE (R)
CHARGING STATION (B)