Jackson Systems Comfort System T-32-P Operation Manual page 8

Press the PROG key again and the LCD will display the word
current mode ( Heat or
selected (shown by both
setpoint and the T-32-P will change to show the next mode setpoint. Press the up ( ) or down ( ) key
to change the setpoint.
Press the PROG key again and the LCD will display
STOP (unoccupied) time and temperature settings. Press the
will appear on the LCD.
Option 1 - Copy Program
To copy the start and stop times you have
programmed to other days of the week, press the
up ( ) or down ( ) key and select each additional
day you wish to duplicate the program. Press the
PROG key again and the word
briefly to confirm the copy process. Normal
programming steps will resume showing the next
day to be programmed.
Option 2 - Different Daily Program
If you chose to have the next day represent a different start and stop time, simply press the
key after the word COPY
programming steps as the prior day. This allows you to have a different start and stop time for each
day of the week.
Temporary Temperature Override
To place the T-32-P in the temporary temperature override mode, press the up ( ) or down ( ) key.
The LCD will show the word
key to change the current temperature setting. Wait 3 second and the next mode (
be displayed and can be changed. When the T-32-P will exit the override program. The word
or STOP will flash confirming the override event. The HVAC installer will have set the override period
from 1 to 12 hours. If during the override period another event takes place, the override will be
canceled. To manually cancel the override, press the
the programmed schedule.
Permanent Temperature Hold
Press the O/RIDE key. The LCD will show the word
cooling temperatures will be held permanently or can be adjusted by pressing the up ( ) or down ( )
key which will display the current program temperature along with the word
down ( ) key to change the temperature.
To return to the programmed schedule, press the
displayed.
7
Cool ). Press the ( ) or down ( ) key to change the setpoint. If Auto mode is
Heat and Cool on the display), wait 3 seconds after adjusting the first mode
COPY will flash
appears and the T-32-P will advance to the next day. Follow the same
SET and the current mode (
SET and the temperature setting for the
STOP . Follow the steps above to program the
PROG key again and the word
MODE O/RIDE
Heat or Cool ). Press the up ( ) or down ( )
O/RIDE key twice. The thermostat will resume
. The current programmed heating and
HOLD
O/RIDE key until the word
COPY
COPY
FAN
PROG
PROG
Heat or Cool ) will
START
SET . Press the up ( ) or
is no longer
HOLD