Residential Programmable Mode - Jackson Systems Comfort System T-32-P Operation Manual

Residential Programmable Mode

Cool
Heat
MODE O/RIDE
MODE KEY
FAN Selection
Press the FAN key to cycle through the fan selections. More details on fan functions can be found on
page 20 of this manual.
Auto The HVAC system fan will only run with a call for heating or cooling.
On The HVAC system fan will run continuously.
Cool
Heat
MODE O/RIDE
UP / DOWN
KEYS
MODE Selection
Press the
operation and the LCD will display the following:
Heat
Cool
Cool
Heat
E. Heat
FAN
PROG
OFF
FAN KEY
Setting the clock
The T-32-P has a real-time clock that is used for
programming functions. It is important that the time
and day of week be set properly so that programmed
events run correctly.
To set the clock, press the
flashes on the LCD. Use the up ( ) or down ( ) key to
set the current hour along with the AM and PM
symbol. Press the
flash. Use the up ( ) or down ( ) key to set the
current minutes. Press the
day flashes. Use the up ( ) or down ( ) key to set the
PROG FAN
correct day of the week. Press the
exit the clock and day of week program.
PROG
KEY
MODE key to cycle through the modes of
Heat Mode
Cool Mode
Auto Changeover (Installer must
activate this mode)
Emergency heat when T-32-P is
configured for a heat pump system
Thermostat is off
PROG
PROG key again until the minutes
PROG
key until the hour
key again until the
PROG again to
2