Commercial Programmable Mode - Jackson Systems Comfort System T-32-P Operation Manual

The LCD will now flash the current program number to remind you that an override is in progress. The
override temperature settings will remain in effect until the override time expires or until the next
scheduled event (whichever comes first). You can return to the programmed schedule at any time by
pressing the O/RIDE
confirming that the T-32-P is now running the programmed schedule.
Permanent Temperature Hold
Press the O/RIDE key. The LCD will show the word
cooling temperatures will be held permanently or can be adjusted by pressing the up ( ) or down ( )
key which will display the current program temperature along with the word
down ( ) key to change the temperature.
To return to the programmed schedule, press the
displayed.
Reviewing Set Temperatures
Your can review the set temperatures at any time by simply pressing the up ( ) or down ( ) key.
Factory Default Schedule

Commercial Programmable Mode

Start
Cool
Heat
MODE O/RIDE
MODE KEY
5
key and then pressing it again. The program number will stop flashing
Default Schedule
Schedule Start Time
1 6:00 AM
2 8:00 AM
3 6:00 PM
4 10:00 PM
PROG FAN
FAN KEY
. The current programmed heating and
HOLD
O/RIDE key until the word
Setpoint (Mon - Sun)
Heating Cooling
70 75
62 78
70 75
62 78
MODE Selection
Press the MODE key to cycle through the modes of
operation and the LCD will display the following:
Heat Heat Mod
Cool Cool Mode
Auto Changeover (Installer must
Cool
activate this mode)
Heat
E. Heat Emergency heat when T-32-P is
configured for a heat pump system
OFF Thermostat is off
SET . Press the up ( ) or
HOLD is no longer