Advertisement
Quick Links
Limit
STAT
TM
O
Models
LSL-HCB
LSL-HCW
Specifications
Compatible Equipment
Output Terminals
Fan Operation
Display
Control Power
Enclosure
Dimensions
Limited Warranty
Application
Limit Stat™ is designed to prevent the
user from adjusting the temperature
beyond a specific heating and cooling
limit, thereby greatly reducing utility
bills.
This installation manual covers both
the LSL-HCB single stage, heat / cool
battery powered and the LSL-HCW
single stage, heat / cool hardwired
Limit Stat™.
Features
Digital, non-programmable
Gas / Electric blower fan operation
Set temperature range (45° to 90° F)
Clean attractive design
Large, backlit, easy-to-read LCD
Built-in short cycle compressor
Adjustable setpoint limits
Single stage, gas, oil or electric heating and air
conditioning systems, Millivolt systems or single
stage heat pumps
LSL-HCB:
G, W, Y, RH, RC, O/B
LSL-HCW:
G, W, Y, RH, RC, O/B, C
Gas or electric
Green backlit LCD
LSL-HCB:
2 AA alkaline batteries (Included)
LSL-HCW:
24VAC, 2.4VA
Molded ABS plastic
3.25" x 5" x 1" (WHD)
1 Year
Installation Manual
Advertisement
Related Manuals for Jackson Systems Limit Stat LSL-HCB
Summary of Contents for Jackson Systems Limit Stat LSL-HCB
-
Page 1: Installation Manual
Limit Installation Manual STAT Application Limit Stat™ is designed to prevent the user from adjusting the temperature beyond a specific heating and cooling limit, thereby greatly reducing utility bills. This installation manual covers both the LSL-HCB single stage, heat / cool battery powered and the LSL-HCW single stage, heat / cool hardwired Limit Stat™. -
Page 2: Thermostat Location
Limit Stat™ Use a properly sized screwdriver and land each wire to its dedicated terminal as illustrated in Section 4. Do not over tighten the terminal screws. Check to ensure that all wires are landed Thermostat Location correctly and dressed properly to prevent any shorts. -
Page 3: Setup Options
Single Stage Heat Pump Systems 24V Common (LSL-HCW Only) Completing Installation Add jumper wire between W1 and Y1 Once all optional jumper settings have been made, replace the batteries if using model LSL- Cool HCB. Install the thermostat on its subbase with 24V Transformer (Hot) the bottom tilted out. - Page 4 Although great care has been taken in preparation of this manual, Jackson Systems takes no responsibility for errors or omissions contained herein. It is the responsibility of the installer to ensure that this thermostat and the equipment connected to it operate in a safe and efficient manner.