Jackson Systems Comfort System T-32-P Operation Manual page 4

Programming 4 daily events
The T-32-P can be programmed to provide 4 individual time-of-day temperature settings for each day
of the week.
Each event is noted on the LCD by numerals
At the start of each event, the programmed heating and cooling temperature will be maintained until
the next event starts.
Cool
Heat
MODE O/RIDE
UP / DOWN
KEYS
Press the PROG key again and
the up ( ) or down ( ) key to select the desired heating or cooling temperature to be maintained for
1 1
the program time period.
1
Press the PROG key again and the opposite mode and a temperature value will be shown on the
LCD. Use the up ( ) or down ( ) key to select the desired temperature to be maintained for the
program time period.
1
Note: There must be at least a 2 degree difference between the heating and cooling temperatures.
The heating temperature must always be lower than the cooling temperature. If you set the heating
or cooling temperature closer than the minimum value, the T-32-P will automatically move one of the
temperature settings to maintain the 2 degree difference.
3
1
Entering the program mode
Hold the
The display will show the number
MON
Use the up ( ) or down ( ) key to set the day you
wish to start programming.
Press the
Use the up ( ) or down ( ) key to set the time you
wish program
PROG FAN
is correct.
Press the
Use the up ( ) or down ( ) key to set the minutes for
program
PROG
KEY
Heat or Cool will be displayed along with the temperature value. Use
2 3 4
PROG key down for 3 seconds.
will flash.
PROG key again and the hour will flash.
to start. Make sure that the AM / PM
1 1 1
PROG key again and the minutes will flash.
1 1 1 to start.
and the day
1 1 1