KTM 2015 RC 390 EU Owner's Manual page 90

12 SERVICE WORK ON THE CHASSIS
Main work
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn adjusting screws
right chain adjusters
The rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even, so you should check the setting at different chain
positions.
–
Tighten nuts
–
Make sure that chain adjusters
–
Tighten nut
L02150-10
Guideline
Nut, rear wheel spindle

.
 .

on the left and right so that the markings on the left and

are in the same position in relation to reference marks

.

are fitted correctly on adjusting screws

.

on the left and right.
5... 7 mm (0.2... 0.28 in)
M14x1.5 90 Nm
(66.4 lbf ft)
88

.

.