Connecting Vehicle Power; Dc To Dc Power Supply Installation; Connecting Electrical Cables To Power Sources - Honeywell MX3Plus User Manual

Connecting Vehicle Power

Complete vehicle cradle mounting and power instruction is contained in the MX3Plus Cradle Guide.
The MX3Plus must have a main battery installed before docking the MX3Plus in a cradle.

DC to DC Power Supply Installation

For use with Honeywell power supplies:
9000301PWRSPLY – Power Supply, 18-60VDC with cable
l
9000302PWRSPLY – Power Supply, 60-110VDC with cable
l

Connecting Electrical Cables to Power Sources

The DC to DC power supply is used to provide vehicle power to the MX3Plus when placed in a DC powered vehicle dock.
Specifications for Electrical Supply
Input Voltage Always observe input voltage range specified on the DC to DC power supply
Output Voltage 12 VDC ± 10%
Power 60 W
Fuse 5 A (slow blow fuse). Fuses are USER SUPPLIED
Note: Refer to the Wiring Schematic
Caution: For proper and safe installation, the input power cable must be connected to a fused circuit on the vehicle. This
fused circuit requires a five Amp maximum time delay (slow blow) high interrupting rating fuse. If the supply con-
nection is made directly to the battery, the fuse should be installed in the positive lead within 5 inches of the battery
positive (+) terminal. Note: For North America, a UL Listed fuse is to be used.
Caution:
For installation by trained service personnel only.
Warning:
Risk of ignition or explosion. Explosive gas mixture may be vented from battery. Work only in well ventilated area.
Avoid creating arcs and sparks at battery terminals.
3-4
for wiring colors and connections.