J600 Rf Connector; J752 Audio Jack; J401 (30 Pin Board-To-Flex Connector) - Motorola IDEN I580 Field Service Manual

NOTE: Indium Indalloy NC771 flux pen (Motorola P/N 1185768C01) must be used for rework of
bottom connector, RF connector and switches.
NOTE: NO FINAL FLUX CLEAN UP IS ALLOWED to avoid flux spreading over/inside gold
contacts/mechanism.
NOTE: No touch ups are allowed (fill lands with a good amount of solder to avoid unsolder leads).
Degradation of component material will affect fit and/or function and may cause future
failures.
9.5.4

J600 RF Connector

Top 330ºC - Bottom 100ºC
OK Industries 151/min
Pace 6/7
NOTE: Use Flux Pen Indium-Indalloy NC771 ONLY (Motorola P/N 1185768C01). Use flux
sparingly.
9.5.5

J752 Audio Jack

Top 330ºC - Bottom 100ºC
OK Industries 151/min
Pace 6/7
9.5.6

J401 (30 Pin Board-to-Flex Connector)

Top 330ºC - Bottom 100ºC
OK Industries 151/min
Pace 6/7
NOTE: Tack down a couple of leads if necessary
68P80401P05
MECHANICAL PARTS REWORK AND REPAIR: Mechanical Parts Rework Procedure
N-P07
"F" over M105, and "F" over J600 during
Installation Procedure.
N-P20
Modified "F" over J752 during Installation
Procedure.
N-Q07
"I" over M002 & part of SH 3 during Removal
Procedure.
"L" over M002 & J401 during Installation
Procedure.
81