Motorola IDEN I580 Field Service Manual page 70

Basic and field level test procedures digital multi-service, data-capable portable

Hide thumbs Also See for IDEN I580:

Table of Contents

4. While carefully pushing the black stick in towards the flip assembly about 2mm, twist the stick

as if you were tightening a screw.

5. Try to compress the hinge spring by moving the stick in a shoveling motion. The front housing

will deflect slightly, allowing the hinge to release the right side from the front housing.

6. Once the Flip Assembly is free of the front housing, carefully feed the Flex Connector through

the slot in the front housing. Take extra precaution to prevent stressing and/or tearing the Flex

Ribbon.

7. Angle the flex connector end slightly while prodding the flex ribbon out through front housing

slot. The flex connector will pass through the slot, albeit tightly.

8. Remove the Hinge Assembly Mechanism by inserting the tip of the black stick into the flex

guard slot and pushing on the hinge assembly tip until it pops out.

68P80401P05

PREPARING FOR FIELD LEVEL TESTING: Remove Flip Assembly

5 7

Figure 7-9.

Table of Contents