Remove Back Housing; 7.12.1 Remove; 7.12.2 Install - Motorola IDEN I580 Field Service Manual

Basic and field level test procedures digital multi-service, data-capable portable

Hide thumbs Also See for IDEN I580:

Table of Contents

PREPARING FOR FIELD LEVEL TESTING: Remove Back Housing

7.12

Remove Back Housing

Tools: T-4, T-6 Torx Bits, Black Stick.

Preparation: Remove Battery Cover, Battery, and Antenna.

1. Remove four T-6 screws—one in the antenna tube channel.

2. Grasp the back housing at the top end and the front housing at the flip pivots. Gently pull apart

the housing halves.

3. Once the housings are free, avoid stressing flex strip near the PTT key.

4. Wedge black stick under flex pad to unseat flex connector.

NOTE: Do not touch flex contacts with fingers or dirty tools. Do not damage the flex strip.

1. Reattach flex connector carefully without contamination (see Figure 7-6).

2. Bring housing halves together checking alignment of flex, PTT/volume keypad, back acoustic

seal, and audio jack seal.

3. Torque screws to 1.8 in/lb (2.1 in/lb new plastic).

Figure 7-6.

68P80401P05

Table of Contents