Table of Contents
Advertisement
4.4
Light Source
1. Light Source Mode
2. Constant Power
3.
Constant Intensity
4. Total Projector Hours
5. Light Sensor
Light Source Mode
Select Constant Power, Constant Intensity or ECO mode. When in ECO mode,
the projector will adjust to the lowest fan speed and switch the laser diode
power to the minimum setting.
Constant Power
Set the value of the laser diode power (in Watts).
Constant Intensity
Set the value for the Constant Intensity to maintain constant brightness.
The light sensor will monitor the light level and will apply more power as the
laser brightness decays naturally over time. When the laser setting reaches
maximum power of 405W, it will remain at this setting. Note that the light
sensor needs to be calibrated for Constant Intensity mode to work properly.
Calibration should be performed again after every lamp change.
Total Projector Hours
Display current total hours the projector used.
Light Sensor
Calibrate light sensor.
GS Series User Manual
020-000724-02 Rev. 1 (10-2015)
Light Source
Constant Power
Section 4: OPERATION
4-14
Advertisement
Table of Contents
