Table of Contents
Advertisement
•
Serial Port Echo: Control whether the serial port echoes characters.
•
Serial Port Path: Select the serial port path from either RS232 or HDBaseT.
•
Projector Address: Set the projector address (0-9). The projector will
respond to IR remotes set either at the same address as the projector or to
IR remotes set to address 0.
Image Blending
Adjust blend widths and settings to left, right, top and/or bottom sides to create
a seamless multi-projector stitched image. (Available only when optional Dual
Processor Warp Module is installed.)
What is a Blend?
In simple terms, a blend appears as a gradient strip along an edge of a
projected image. It is darkest along the extreme edge of the image, and
lightens nearer to the rest of the image(see below).
How are Blends used?
In multiple-projector wall, complementary blends between neighboring images
can compensate for the extra "brightness" or intensity where these edges
overlap. By controlling blend width and other properties, you can achieve
uniformity across the group of images. "Visible overlaps will disappear, as
shown below"
Overlap
Blending regions can be defined on all sides - left, right, top and bottom. The
same gamma curve is used for all blending regions.
GS Series User Manual
020-000724-02 Rev. 1 (10-2015)
Overlap
Proj. 1,1
Proj. 1,2
Image
Proj. 2,1
Proj. 2,2
Section 4: OPERATION
Blend
With edge blending:
Blend
Proj. 1,2
Proj. 1,2
Proj. 1,1
Image
Proj. 2,1
Proj. 2,2
Blend
4-11
Advertisement
Table of Contents
