Veilux SVR-1648D1 User Manual page 51

Table of Contents

Advertisement

1. Fault State : The storage device is completely damaged, and none of the S/W operations can
be performed. The fault state is not related to a DVR problem. The DVR has detected the fault
and stopped the recording.
2. Warning State : The storage device has a physical error that can be corrected by the storage
device or by the DVR. If the error is not taken care of, however, the storage device is likely to
be damaged (and shift to fault state). Backing up data in the corresponding storage device and
replacing the device with a normal one are strongly recommended.
3. If there is an active storage device with a warning or a fault, a message is displayed on the
upper left part of the screen.
(3) Instruction when adding the local storage device
① Open the system body and install a new disk (connect the data cable and the power cable)
② Connect power to the system and boot the system.
③ Select {Menu} {Setup} {Storage} by using the arrow keys and the Select button.
④ A newly displayed disk will then be displayed as {New}.
⑤ Select a newly installed disk by using the arrow keys and the Select button and initialize the disk as a
{Direct} or a {Backup} disk. The following describes the method of setting the saving(direct) storage.
⑥ {Direct} shows the status of the newly installed disk online.
※ Selecting {Direct-Init} or {Backup-Init} causes all data in the device to be erased.
Therefore, caution is required.
※ While {Direct-Init} or {Backup-Init} is being set up, do not remove the device (may
cause an error when detecting the device).
※ To use the external or portable storage device for system upgrade, set to {Backup-
Init} in the {New} item for {Main Setup} {Storage Device} {Local Storage Device Man-
agement}.
※When used in DVR equipment for the first time, a backup USB device will always be
detected in the {New} category. Therefore, a USB device in the {New} category must be
set up as {Backup-Init} prior to use for backup. A USB device that has gone through
this procedure will be detected in the {Backup} category when used again in the DVR
equipment.
51

Advertisement

Table of Contents
loading

Table of Contents