Table of Contents
Advertisement
① Select Motion Area of each channel.
② It becomes the 1 channel division mode and rectangular boxes appear where motions occur. Drag the
yellow pixel cursor by using the mouse or the front button/remote controller and select pixels where motion
detection doesn't applied. The selected area turns brown.
③ Select Exit to finish.
(1)Motion Sensitivity : Lowest/Low/Middle/High/Highest.
(2)PCD Time : Select between 2/3/4/5/6/7/8/9.
(3)Sensor Type : Select the sensor type.
(4)Sound Sensitivity : Lowest/Low/Middle/High/Highest
６-２-４ Relay Select the relay type.
６-３ Action
The Main setup is to configure the environment of record and system and major functions.
In the real-time monitoring, move to {Menu} {Setup} {Action}
[Figure 5-40. Motion Area Setup]
[Figure 5-41. Setup / Action]
46
Advertisement
Table of Contents
