Table of Contents
Advertisement
11 – Other Settings, Information Screens and Keyboard Operations
Setting the power redundancy check
function (DA-6400dp only)
The DA-6400dp has two power supply circuits to allow
redundant power, which can prevent problems caused by power
supply issues.
When shipped new from the factory, the power redundancy
check function is set to ON. To use this function, connect each
circuit to a different power supply.
When the power redundancy check function is ON, if the unit
determines that one power supply connection has been inter-
rupted, the INFO indicator will light red.
To disable the power supply redundancy check function, select
the
POWER
REDUNDANCY CHECK
page.
ENCES
1. Select the
POWER
REDUNDANCY CHECK
page to open the
PREFERENCES
screen. (See "Menu operation procedures"
DANCY CHECK
on page 16.)
2. Turn the power redundancy check
Options:
(default),
ON
OFF
3. Confirm the setting and return to the Menu Screen.
NOTE
When making a setting, you can press the EXIT [PEAK
CLEAR] button to cancel the changes and return to the
Menu Screen.
Exporting/importing system backup
data
You can export the system backup data from the unit's built-in
memory to a USB flash drive connected to the USB2.0 port on
the front of the unit. You can also import this data.
1. Select the
SYSTEM BACKUP
page to open the
SETUP
"Menu operation procedures" on page 16.)
2. Select whether to export or import system backup data to or
from a USB flash drive.
: export system backup data to a USB flash
Export
drive
: import system backup data from a USB flash
Import
drive
3. Press the MULTI JOG dial.
A confirmation pop-up message will appear.
item on the
PREFER-
item on the
POWER
REDUN-
function on
or off.
item on the
SYSTEM
screen. (See
SYSTEM BACKUP
Pop-up message when set to Export
Pop-up message when set to Import
4. Press the MULTI JOG dial again.
A confirmation pop-up message appears again.
Pop-up message when set to Export
Pop-up message when set to Import
5. When the confirmation message is open, press and hold the
MULTI JOG dial to begin exporting to or importing from the
USB flash drive.
When exporting/importing ends, the
screen reopens.
NOTE
• When
was selected, one of the following pop-up
Import
messages will appear if importing did not complete
properly.
If the connected USB flash drive does not contain a
system backup data file
If the system backup data file on the connected USB
flash drive does not contain valid data
If importing completed, but some data with problems
was not imported (part of the system backup data file is
damaged)
TASCAM DA-6400/DA-6400dp
SYSTEM BACKUP
55
Advertisement
Table of Contents
