Table of Contents
Advertisement
a SHIFT button
o When the Home Screen is open, press the MULTI JOG
dial while pressing and holding this button to show a
white frame in the meter section, and turn the MULTI JOG
dial to select the audio channel to be output from the
PHONES jack.
o When the Home Screen is open, press and hold the MULTI
JOG dial while pressing and holding the SHIFT button to
switch the headphone monitoring mode between STEREO
and MONO. (See "Setting headphones monitoring mode"
on page 20.)
o When the meter mode setting is 32ch, press the HOME
[METER] button while pressing and holding this button
to switch between showing level meters for channels 1-32
and 33-64 on the Home Screen. (See "Setting the meter
mode" on page 53.)
Rear panel
DA-6400 rear panel
8
DA-6400dp rear panel
8
s SLOT 2
Use this slot to install an I/O card (sold separately).
d SLOT 1
Use this slot to install an I/O card (sold separately).
f TIMECODE IN connector
This BNC connector is for the input of SMPTE timecode.
g TIMECODE OUT connector
This BNC connector is for the output of SMPTE timecode.
h WORD/VIDEO THRU/OUT connector
This BNC connector is for the output of word clock and video
reference signals.
This connector outputs word clock signals (thru or 44.1, 48,
88.2 or 96 kHz) and video reference signals (signal thru from
IN jack).
j WORD/VIDEO IN connector
This BNC connector is for the input of word clock and video
reference signals. Use this connector to input word clock
signals (44.1, 48, 88.2 or 96 kHz) and video reference signals
(NTSC/PAL blackburst and HDTV tri-level).
2 – Names and Functions of Parts
o Press the INFO button while pressing and holding this
button to open the
o Press the MENU button while pressing and holding this
button to open the menu
o When an audio output channel is selected on the Home
Screen, when a channel is selected for setting changes on
the
REC FUNCTION
when a folder is selected on the
MULTI JOG dial while pressing and holding this button to
move the cursor by large amounts.
When stopped, in playback standby or playing back.
o Press this button while pressing and holding the .
[MARK .] button to move to the previous mark and
resume the previous state.
o Press this button while pressing and holding the /
[MARK /] button to move to the next mark and
resume the previous state.
k ETHERNET connector
This is an Ethernet port. Use this to connect to a network,
transfer files and control the unit externally.
l RS-422 terminal
This is a 9-pin D-sub RS-422 serial control terminal.
Connect an external controller here.
; PARALLEL connector
This is a 15-pin D-sub parallel control terminal.
Connect an external controller here.
z Heat dissipation fan
This fan is to prevent the unit from overheating. Do not
allow anything to block the fan and prevent the dispersion
of heat.
x AC IN connector (DA-6400 only)
Plug the included power cord in here.
c AC IN A/B connectors (DA-6400dp only)
Plug the included power cords in here.
To operate the unit with power supply redundancy, connect
power supplies to both the AC IN A and AC IN B connectors.
page.
MARK INFO
pages
in the opposite direction.
or
INPUT MONITOR
screen, turn the
BROWSE
TASCAM DA-6400/DA-6400dp
screen, or
11
Advertisement
Table of Contents
