Setting The Up-Converter - Panasonic AV-HS410N Operating Instructions Manual

2. Input/output signal settings

2-1-6. Setting the up-converter

Select the settings for SDI IN5 to SDI IN8, as well as for the
up-converter that is built into the option boards listed below:
 AV-HS04M1 (SDI Input Board)
 AV-HS04M2 (Analog Input Board)
 AV-HS04M6 (Analog Composite Input Board)
1 On the Input sub menu, use [F2] to select the input to
be set using the Select item.
 Refer to "2-1. Input signal settings".
2 Use [F1] to display the Up Converter1 sub menu.
3 Use [F2] to select the scaling system using the Scale
item.
Squeeze
The image is enlarged both horizontally and
vertically to fill the entire screen.
Edge Crop The aspect ratio of the image is maintained,
the image size is increased in accordance
with the vertical resolution, and black bands
are added at the left and right.
Letter Box The aspect ratio of the image is maintained,
the image size is increased in accordance
with the horizontal resolution, and the image
is cropped at the top and bottom.
Input image
Edge Crop
4 Use [F3] to set the image movement detection
sensitivity using the Move Detect item.
1
Toward still images
 
3
Standard
 
5
Toward moving images
5 Use [F4] to set the extent of the edge sharpness for the
6 Use [F5] to adjust the input image size (100 % to
Fine-tuning of image positions
Fine-tuning of image positions is performed when "Edge
Crop" is selected for the scaling method.
1 Use [F1] to display the Up Converter2 sub menu.
2 Use [F2] to select the image position using the Edge
Squeeze
Setting the gamut limiter
Letter Box
1 On the Up Converter2 sub menu, use [F4] to set the
78
images using the Sharp item.
1 Not sharp edges
 
3 Standard
 
5 Very sharp edges
110 %).
Crop Pos item.
Center The image is positioned at the center, and
black images are added at the left and right.
Right
The image is positioned at the right, and a
black image is added at the left.
Left
The image is positioned at the left, and a
black image is added at the right.
color range of the input signals using the Limiter item.
Off
The color range is not restricted.
108 The amplitude level of the colors (R, G and
B) is restricted to 0 % - 108 %.
104 The amplitude level of the colors (R, G and
B) is restricted to 0 % - 104 %.
100
The amplitude level of the colors (R, G and
B) is restricted to 0 % - 100 %.