Connect the positive cable (5), previously assembled
to ABS cable (6), to battery positive terminal, and
negative cable (7) to battery negative terminal, by
starting the other screw (4) in its thread.
Tighten the terminal clamp screws (4) to a torque of
5 Nm ±10% and apply grease onto the battery
terminals to prevent oxidation.
Reposition the battery (3) in the support, positioning
the cables (5) and (6) as shown in (Fig 140).
Refit battery mounting cover (2) and fasten,
tightening the screw (1) to a torque of 10 Nm ±10%.
Refit the left-hand side fairing (page 215).
224
4
2
7
Fig 143
1
Fig 144