The Driving Parameter Editor - Siemens AT 18 Operating Instructions Manual

Rev.01 Issue 09/05
14.12.2 Driving parameter editor
Figure 14
With the run time curve editor all adjustable parameters can be loaded, comfortably adjusted and
saved. The loading as well as the saving of parameters can be done in the AT18 controller. A text
file can also be saved on the PC.
It is also possible to use run time curves saved on the PC for the start-up of another identical lift
door.
For this the following buttons are used:
- "Load data from door controller"
- "Transfer data to door controller"
- "Load data from file"
- "Save data to file"
Additional buttons are "Select profile" and "Door commands".
Clicking a run time curve value on the left side of the editor menu (Figure 14) marks this value on
the run time curve shown on the right.
Likewise clicking a ramp or another drive value in the run time curve diagram marks the
appropriate value in the parameter list so that it can be easily found.
The change of a value directly affects the represented form of the run time curve.
As a help the current parameter as well as any exceeded limits are referenced in the upper right
menu window.
The return from the run time curve editor is accomplished with the "Main Menu" button.
43 Operating instructions AT18 SEDM