Operating Status Display - Siemens AT 18 Operating Instructions Manual

11 Operating status display

The 7 segment display H5000 shows the following operating conditions:
Display
0 Signal light barrier active (light barrier interrupted)
1 RAM -, EEPROM or CPU error (system error)
2 EEPROM error
3 Error in the second power-off sequence
4 Increase of the open time with increased motor duty cycle
5 Motor undefined
6 Motor blockage in closing direction
7 Pulse generator error
8 Minimum editor is started (service button OPEN and CLOSE operated at the
same time)
9 Motor over current
A Minimum editor (force adjustment) active
B Reserved
C Blockage when opening
C Minimum editor (profile setting) active
D Door remains standing during initialization run (no OPEN or CLOSE signal)
E Motor over voltage
F Motor under voltage
h Reserved
H Parameter determination (training run)
n Friction values of the door too high
L Current measurement error
o Function O. K.
P Parameter error (error during the training run)
u Door is closed
U Max. door mass exceeded
- Controller waiting for training run
18
Rev.01
Meaning
Operating instructions AT18 SEDM
Issue 09/05