Siemens AT 18 Operating Instructions Manual page 40

GENERAL SETUP
39
Rev.01
Profile parameter
Slow end open distance ... mm
Slow start open distance ... mm
Slow start close distance ... mm
Slow end close distance ... mm
Maximum speed open ... mm/s
Slow end speed open ... mm/s
Slow start speed open ... mm/s
Slow speed open initial... mm/s
Maximum speed close ... mm/s
Slow start speed close ... mm/s
Slow end speed close... mm/s
Slow speed close initial ... mm/s
Nudging speed ... mm/s
Acceleration ramp open ... mm/s²
Deceleration ramp open ... mm/s²
Reversal ramp open/close ... mm/s²
Acceleration ramp close ... mm/s²
Deceleration ramp close ... mm/s²
Reversal ramp close/open ...mm/s²
Idle torque open ... A
Idle torque close ... A
Peak torque close ... A
Limit force open ... N
Limit force close ... N
Limit force end close ...N
Limit force close nudging ... N
Start initial learn run
Start normal learn run
Set default parameter
Issue 09/05
Operating instructions AT18 SEDM