Usb Hid Via The Cradle; Activate Usb Hid & Select Keyboard Type; Usb Hid Via - Metapace S-2 Hardware Manual

Metapace S-2 Hardware Manual

2.6 USB HID VIA THE CRADLE

For USB HID, use the USB cable to connect the scanner via the cradle to the USB port of
PC and connect the power supply cord if necessary. Run any text editor on your
computer, and the scanned data will be transmitted to the computer.
HID Settings
Keyboard Type
Digits Layout
Capital Lock Type
Capital Lock State
Alphabets Transmission
Digits Transmission
Inter-Function Delay
Send "NR" to Host
2.6.1 ACTIVATE USB HID & SELECT KEYBOARD TYPE
When USB HID interface is activated, you will have to select a keyboard type to complete
this setting.
Activate USB HID & Select Keyboard Type ...
1) Read the label above to activate USB HID and select a keyboard type.
2) Read the "Decimal
of desired keyboard type.
3) Read the "Validate" label on the same page to complete this setting.
74
Value" label on page 195. Refer to the table below for the number
Defaults
PCAT (US)
Normal
Normal
Off
Case-sensitive
Alphanumeric keypad
0 (ms)
Disable
Enter Setup