Scan Modes - Metapace S-2 Hardware Manual

Metapace S-2 Hardware Manual

1.6 SCAN MODES

Different scan modes are supported – select the scan mode that best suits the
requirements of a specific application. Refer to the comparison table below.
Scan Mode Start to Scan
Always
Continuous mode
Test mode
Laser mode
Auto Off mode
Auto Power Off
mode
Aiming mode
Multi-Barcode
mode
Alternate mode
Note: By default, the scan mode is set to Laser mode.
32
Press Hold Press
trigger trigger trigger
once twice
Stop Scanning
Release Press Barcode
trigger trigger being
once read
Enter Setup
Timeout