Metapace S-2
Hardware Manual
1.3.1 GOOD READ LED
*Enable Good Read LED
Disable Good Read LED
1.3.2 GOOD READ LED DURATION
By default, the Good Read LED stays on for 40 milliseconds. Specify a value, ranging
from 1 to 254 in units of 10 milliseconds.
Good Read LED Time-Out after
0.01~2.54 seconds (*40 ms)
1) Read the label above to specify the time interval before the Good Read LED goes off.
2) Read the
"Decimal
Value" label on page 195. For example, read "1" and "5" for the
Good Read LED to go off after 150 milliseconds.
3) Read the "Validate" label on the same page to complete this setting.
26
Enter Setup