Cradle Serial Commands - Metapace S-2 Hardware Manual

CRADLE SERIAL COMMANDS

Normally, you can configure the cradle by having a connected scanner read
cradle-related setup labels.
1) Connect the interface cable, RS-232 or USB, between the cradle and your computer.
2) Connect the power supply cord from the cradle to a proper power outlet.
3) Refer to 3.1.1 Connect to the Cradle
Read the "Set Connection" label first, and then the "Serial Number" label. Both labels
can be located at the back of the cradle.
4) Read the following labels in sequence to configure the cradle.
For cradle-related setup labels, refer to the Serial Command table below. Note that
for the "Version" and "GetID" labels, you must run HyperTerminal.exe or any text
editor to receive the information.
If the output interface is USB Virtual COM or RS-232, run HyperTerminal.exe on
your computer to receive the information.
If the output interface is USB HID, run any text editor to receive the information.
for the target scanner to connect to the cradle.
Enter Setup
(Cradle-related setup labels)
Update
Appendix I Host Serial Commands
Update
187