Test Mode; Laser Mode; Auto Off Mode - Metapace S-2 Hardware Manual

Metapace S-2 Hardware Manual

1.6.2 TEST MODE

The scanner is always scanning.
Capable of decoding the same barcode repeatedly without removing it, for testing
purpose.

1.6.3 LASER MODE

The scanner will start scanning once the trigger is hold down.
The scanning won't stop until (1) a barcode is decoded, (2) the pre-set timeout
expires, or (3) you release the trigger.
Note: Refer to "Scanning Timeout".

1.6.4 AUTO OFF MODE

The scanner will start scanning once the trigger is pressed.
The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout
expires.
Note: Refer to "Scanning Timeout".
34
Test Mode
*Laser Mode
Auto Off Mode
Enter Setup